SABRECRAFT CUSTOM WB7400 COMMERCIAL WORK BOAT WITH DUAL 90HP COMMERCIAL SEA  

CUSTOM WB7400 Commercial Work Boat with Dual 90HP Commercial SeaPro Engines

Just landed from a project in Asia as support vessel for pontoon mooring and barge operations- boat went back to factory for full once over, brand new roof and full paint job so hull is practically as good as a new one and brand new large console for Australian height. No longer required for our upcoming project needs so keen to move it on.

Approx 450 hrs each engine - large amount of time spent on standby at idle.

On engine acceptance recorded up to 30 knots with ease. Solid reliable workboat would suit many uses. Built late 2022

Standard Specs
- 4/5mm Marine Grade 5083 H116 Aluminium
- 7.4m Long x 2.3m Wide x 0.75m High
- Floor is double plate fully welded with 100 x 50 RHS cross bracing
- 120lt aluminium fuel tank fitted into transom behind seat
- 4x Lifting Lugs
- Twin Batteries with high amperage isolation switch
- 2x 2000 GPH Bilge Pumps
- Navigation Lights
- AMSA Form 579 2E - CE Approved 2D

Additions from Standard Model
- Full Side Fenders top/bottom/angled
- Upgraded Large Console
- Hydraulic Steering with Stainless Steering Wheel
- Full Engine Bump Guard
- 75mm 12V Capstan Winch
- Large custom braced roof - removable if required
- 7x Upgraded Bollards - higher spec, larger size and welded through frame to floor - 3 each side, 1 centre of bow
- Large reinforced wide front push bar with 4 supports and rubber strip - pushes any barge or pontoon with ease
- rear ladder
- includes Tandem Trailer ready for registration

Available now - open to reasnable offers.