BODEN NORTH SEA  

2022 BODEN MOTOR CRUISER
(Ref No fb712)

TIMBER
Unfished project
12.71m x 4.53m x 1.6m
Design - Boden North Sea
Purpose - short/long range cruising
Displacement hardchine
Wheelhouse amindships
Construction - marine ply over oregan framing
Hull epoxy coated & with f/glass skin.
Keel - strengthen above design specs.

Machinery -
(Main) Ford 120hp (rebuilt, not yet started. Hours - nil)
Cooling - heat exchange
Exhaust - dry
Gearbox - Newage PRM 3:1
Speed - designed 7 kts@ 1800rpm / 8 kts @ 2500rpm
Consumption - 6 l/ph cruising

(Auxiliary) Volvo 24hp 2 cyl. Driving a line shaft with
24 volt & 240 volt alternators, Japsco water pump & hydraulic pump

Steering - hydraulic + emergency tiller
Shaft - 316 2" Stainless Steel
Propellor - 22 x 31
Deck gear - anchor winch (hydraulic) fitted with 300 ft x ½" galvanised chain
Also 250m x 24mm rope on Stainless Steel spool aft
Lathe - metal in saloon.
Pedestal drill in saloon

Electronics (not fitted & older models) - radar, echo sounder, auto pilot & GPS

Galley & living quarters
Two cabins & saloon
Toilet
Shower
Hot water
Water pressure pump
Stove - four-burner electric hot plate
Sink

Fixtures & fittings

Tanks - all Stainless Steel
Fuel - 4 x 800 litre tanks
Water - 8 x 90 litres in floor below saloon
Hydraulic tank
Hand rails - 1 ¼" Stainless Steel
Mast & boom - oregan (not fitted, no rigging)
Chain plates to support the mast/rigging are built into the sides of the cabin
Yard trolley to move vessel around

Comments :
This is a vessel built by a tradesperson over many years for the traditionist timber boat lover.
It was a carefully selected design suitable for minimum crewing to cruise on the Australian coast.
Thousands of hours have gone into this labor of love - giving the builder much enjoyment to
achieve the standard of workmanship what he has today.
There is still work to be done before the launching of this new construction.
The owner has realised in recent times that while he would still like to complete the build,
age and health wise this is not going to happen.
He would dearly love to see another enthusiast take over and complete the project.

The engineering machinery inside the boat can be sold in the deal or removed.

The vessel owner would consider a vintage or classic motor cycle as a part trade on this unfinished motor cruiser.

Location : Victoria

Price : $189,900 (GST not applicable)