Jeanneau Sun Odyssey 52.2

In its current state, the vessel is best viewed as a sound structural platform requiring refit attention before
extended cruising. Once the identified items are addressed, Windjewel has the potential to return to reliable
service as a capable blue-water cruiser.
Surveyor Recommendations
Priority Maintenance
o Replace seized seawater-pump impeller and verify full raw-water circulation on restart; inspect heat
exchangers, strainers, and hoses while running.
o Inspect and remediate softness in the port-side deck; re-core and reseal deck hardware as required.
o Replace corroded keel-bolt nuts and washers; confirm torque and thread integrity during haul-out.
o Conduct full rigging inspection and tension verification by certified rigger; replace standing rigging if age
cannot be confirmed.
o Overhaul electrical system: test and reconfigure solar controllers, replace faulty 600 W inverter and 4000 W
inverter, and install a marine-grade multi-stage charger.
o Replace aged canvas, dodger, and clears to restore weather protection.
o Recharge and load-test all batteries; replace any that fail to hold charge.
o Service or replace deployed inflatable lifejacket cylinders and replace expired flare packs to maintain
compliance.
o Restore operation of navigation lights and horn to meet COLREGS requirements.
o Recommission the anchor-windlass system: reinstall wiring, test motor and foot switches before use.
Routine Maintenance
o Replace worn teak on swim platform and refinish cockpit and side-deck teak where serviceable.
o Clean, wire-brush, and re-coat engine mounts; check alignment during next service.
o Polish and reseal topsides and waterline stripes to improve presentation.
o Clean and re-flowcoat exposed bilge areas to protect laminate.
o Replace brass engine-room seacocks with composite or DZR bronze alternatives.
o Renew upholstery, linings, and floor varnish to restore interior finish.
o Perform full LED lighting upgrade and label all electrical circuits.
o Service Lewmar winches and lubricate running rigging hardware.
o Inspect bonding continuity and verify electrolysis blocker operation.
o Continue regular antifoul renewal and anode replacement on a 12-18 month cycle.
o Verify engine operation, oil pressure, and cooling temperature under load once recommissioned

NOTE:
1. The particulars and specifications have been supplied by the seller. Such particulars and specifications have not been verified by Ben Lexcen Marine Brokers. It is the purchaser's responsibility to verify the accuracy of such particulars and specifications.
2. All items listed above are expected to be in working order unless otherwise noted