Sweden Yachts 41

Length under water: 10.00m
Ballast: 3700 kg
I: 16.85 m
J: 5.20 m
E: 4.25 m
IOR rating approx. : 32 tons

Hand-crafted solid laminate bottom, sandwich topsides with generous thicknesses of GRP typical of the design philosophies of Nordic shipyards of the time.
Selden aluminum mast, two spreaders, spiral rigging, Hasselfors Sweden turnbuckles, rigid spring vang. Selden boom with automatic mooring lines. Edson Marine steering system.

Four cockpit winches (two electric), two on the deckhouse, and one on the mast, all "Barlow Australia" in chromed bronze.

The first digit (5) indicates the project identification number (the model). The second two (#05) indicate the hull's serial number.
Italian flag.
The vessel's general refit was carried out between 2015 and 2016 at the Porto Lotti shipyard. Continuous maintenance over the last nine years has been carried out regularly and without cost savings, as the vessel is currently used for summer cruises and weekend trips.

istorical information and maintenance status of the vessel:
- When purchased by the current owner (2015), the boat was equipped with a Volvo D2-40 engine, installed new in 2008 by the previous owner and used for 150 hours. Having been inactive for a few years, it was overhauled and serviced immediately after the boat's purchase. It currently has approximately 800 hours of operation;

- Engine services are performed annually, the last in April 2024 by the authorized Volvo Penta O. M. R. Workshop in Villafrate (Massa Carrara). The annual service includes a change of the engine oil, oil filter, diesel filter, SEPAR diesel pre-filter, water impeller, water impeller oil seal. The alternator belt is replaced every two years, as well as the antifreeze, and the S-drive oil is drained out of the lower drain. The air filter is replaced every three years;

- Diesel tank cleaned every three years, the last time in 2022;
- In October 2024, the heat exchanger and exhaust riser were replaced, both by the "O. M. R. " workshop in Villafrate, using original Volvo spare parts;
- S-Drive bellows replaced in 2015 and again in April 2022, both times by "MotorVela Srl" of La Spezia;
- Volvo 3-blade folding propeller from 2015;
- Teak deck from 2008 by Porto Lotti Shipyard, completely re-rubbed in 2015 by Porto Lotti Shipyard;
- Full-batten mainsail with two reefs and a 150% Dacron Genoa from 2015,"VELMAN" Massa Carrara, designed by Alberto Manfredini;
- Mainsail lazy bag, 2015, overhauled in 2024;
- Removable carbon bowsprit "Carboway" from 2015;
- General mast check (mast electrical system, TV antenna, radar reflector) + Teflon mainsail raceway in 2015;
- New stainless steel mast base, 2015;
- Rigging check in 2015;
- Deck hardware updated and overhauled, 2015 and later.
- Replacement of 8 "Spinlock" halyard stoppers, February 2018;
- Replacement of backstay and forestay + "Bamar" furler, 2015;
- Replacement of hydraulic backstay tensioner with "Navtec", like the original, 2016;
- All sheets, halyards, and lines completely replaced, 2015;
- Baby stay stay in textile with original "Barlow Australia" tensioner + running shrouds replaced, 2015;
- Complete repainting of topsides and deckhouse 2015, polishing every two years;
- "International" preventive treatment on the bottom with epoxy resin, 2015 and again in 2022;
- Complete overhaul of the original "Sestrel England" compass by Fuselli Bussole in Genoa, 2015;
- Complete disassembly of the "Edson Marine" steering system with bearing replacement, overhaul of the bushings and cables, May 2017, annual maintenance (lubrication and adjustment of the cables);
- Moosehide wheel covering;
- Overhaul and rechroming of winches between 2016 and 2017;
- 75 meters of high-strength "ACQUA7" chain, made by Maggi, 8 mm (weight 1.4 kg/m, breaking load 70 kg/mm2), new in May 2017;
- "Lofrans" 1000 W windlass motor, new in 2024, annual gypsy service.
- "Delta" anchor, 21 kg, 2015;
- Windshield cover, turnbuckle covers, hoods and various covers, fenders, mooring lines, etc., replaced in 2015 and serviced when necessary; 2015 "Arimar" 3-seater dinghy + "Mercury 3.3" outboard motor;
- Bronze seacocks replaced in 2015;
- LED lights inside and out, 2015;
- Three 120 Ah AGM deep cycle service batteries + 90 Ah AGM Start&Stop engine battery dated July 2023;
- 12-inch "Raymarine a-series lighthouse" touch-screen chartplotter with integrated fishfinder, 2015;
- Wireless "Raymarine Tacktick" anemometer and depth gauge, interfaced with the chartplotter (via the "micronet ray" system) from 2015;
- AIS system mod. Raymarine 350 receiver with integrated splitter, 2018.
- Raymarine DSC VHF, fixed model, Ray 50,2015;
- Cobra Marine water